Sheye Metal supplies 2000mm 2507 stainless steel plates for fabricators who need wider material for demanding equipment. This Vietnam-bound order features 10 × 2000 × 6000 mm plates intended for a complex flue gas desulfurization (FGD) system.
Photographs taken on 14 September 2026 show the plates during routine checks before shipment: width and length measurement, thickness readings at different points, plate marking and positive material identification (PMI). Together, these checks connect the ordered size and grade with the physical material being prepared for dispatch.
2000 mm width: more room for the fabrication plan
The key requirement in this order is the 2000 mm plate width. For larger panels and fabricated sections, wider plate gives the cutting team more flexibility. Where the component layout allows, it can reduce the need to join narrower pieces and improve how parts fit on the available plate.
The benefit depends on the drawings, cutting allowances and fabrication method. Width therefore belongs in the early purchasing discussion, alongside thickness, length and quantity.
For this order, Sheye Metal prepared 10mm 2507 stainless steel plates in 2000mm width, with a nominal length of 6000 mm and a No.1 finish indicated by the plate marking. Our 2507 stainless steel plate supply range gives buyers a starting point for discussing dimensions and delivery requirements.
Quality assurance starts with checking the actual plate
Wide-plate supply needs practical verification before dispatch. The photographs record the dimensional and material-identification checks for this Vietnam-bound order.
Width and length. Tape measurements check the plate dimensions against the order requirements. The overview and close views show the measuring setup and the plate edges.
Thickness. Measurements at different positions provide more information than a single reading. The nominal 10 mm designation is the ordered thickness; measured values must be assessed against the agreed purchase specification and dimensional tolerances.
Marking and traceability. The photographed marking identifies the grade, nominal dimensions, No.1 finish and heat number 5821967. These identifiers provide a basis for comparing the physical plate with the order and its material documents.
PMI alloy identification. The handheld analyzer displays a 2507 grade match, with chromium, nickel and molybdenum readings. This screening helps identify the alloy and reduce the risk of material mix-ups. It complements the required mill test documentation; handheld XRF does not establish carbon or nitrogen content.
These basic checks make the preparation work visible to the buyer. Required certificates, acceptance criteria and supplementary testing should be agreed for the order through our quality and delivery process.
2507 for demanding FGD service
FGD systems remove sulfur dioxide from flue gas. Wet sections can expose equipment to corrosive liquids, including acidic and chloride-bearing conditions. Super duplex 2507 combines high strength with resistance to localized corrosion, making it an option for suitably specified gas-cleaning equipment. Outokumpu discusses duplex stainless steel in FGD applications.
Selection depends on the operating temperature, liquid chemistry and the particular part of the system. The project specification should define material, fabrication and testing requirements together.
Supplying 2000 mm wide 2507 plate to Vietnam
For buyers sourcing 2000 mm wide 2507 stainless steel plate for Vietnam, this order demonstrates Sheye Metal's wide-plate supply capability and the inspection work behind it.
Send us your thickness, width, length, quantity, destination and project specification. Include required certificates, dimensional tolerances and any additional testing or third-party inspection at the enquiry stage, so the supply and acceptance requirements can be agreed before the order is placed.
Need 10 × 2000 × 6000 mm 2507 plate for your next project? Contact Sheye Metal to discuss your material and inspection requirements.
PRODUCTS